Faucet Service

The plumbers in our network handle the full range of faucet work: stopping drips, replacing worn cartridges and washers, fixing leaks at the handle and base, clearing clogged aerators, and installing new kitchen, bathroom, and utility faucets. Whatever your faucet is doing, you get matched with a pro who fixes it right.

Tightening an aerator or swapping a simple washer is fine for a handy homeowner. But once you're dealing with a worn cartridge, a leak inside the wall, or a full fixture install, a pro saves you stripped parts, water damage, and a second trip to the hardware store. The plumbers we work with finish the job clean and leak-free the first time.

Cost comes down to the type of repair, the faucet brand and parts, and whether you're fixing or fully replacing the fixture. Most faucet repairs run about $150 to $350, while a new faucet installation typically lands between $250 and $600 with the fixture included. Your plumber gives you a clear price before any work starts.

Yes. A faucet that won't shut off or is leaking under the sink can't wait, and the plumbers in our network offer same-day and emergency calls. Reach out and we'll connect you with a local pro who can get to you fast and stop the water.

Plumber Pros matches you with vetted local plumbers who show up prepared, quote honestly, and do clean, lasting work. You skip the hassle of vetting strangers and get a trusted pro for your faucet, plus the same network for any plumbing job down the road.

Many Greensboro homes sit over a crawlspace, so plumbers access the supply and drain lines from underneath. That makes repairs easier than under a slab, but those exposed pipes still need insulation and moisture protection to avoid freezing and corrosion.

Mid-century Greensboro homes commonly have copper supply lines and cast-iron drains that are now decades old. Pinhole copper leaks, slow cast-iron drains, and original fixtures or water heaters are the usual things that need attention at this age.

It depends on the scope. Small repairs in Greensboro usually do not need a permit, while installations, water-heater replacements, and gas-line work generally do under North Carolina code. A licensed local plumber will pull any required permit for you.

Pricing in Greensboro comes down to the scope of work, parts, and which local pro you choose. Because quotes vary, comparing a couple of no-obligation estimates is the best way to find a fair rate.